Amplif12

R1200-1D 1,200 Watt Class-D Mono Amplifier

The PRIME R1200-1D is an ultra-efficient mono amplifier that can produce 1,200 Watts into a 1-Ohm load without taxing the electrical system. The frequency response of the R1200-1D is optimized exclusively for use with subwoofers.

  • 12dB/octave crossover
  • Tri-stage protection covers thermal, over-current and short circuits.
  • Remote PLC (Punch Level Control)
  • On-board Punch EQ with +18dB boost @ 45Hz.
  • RCA pass-thru
  • 4 Gauge power/ground terminals
  • Cast aluminum heatsink
  • Infrasonic filter
  • RCA pass-thru
  • Top mounted controls
Amplif13

P1000-1bd 1000 Watt Class-bd Mono Amplifier

The Power T1000-1bdCP is a 1,000 Watt mono amplifier featuring Constant Power delivering up to 25% more power across all impedance loads. The frequency response of the T1000-1bdCP is optimized exclusively for use with subwoofers.

  • 24dB/octave crossover
  • 4 Gauge power/ground terminals
  • Audiophile grade speaker connections
  • MOSFET power supply
  • MOSFET output stage
  • RCA pass-thru
  • Infrasonic filter
Amplif14

T1000-1bdCP 1000 Watt Class-bd Constant Power Amplifier

The Power T1000-1bdCP is a 1,000 Watt mono amplifier featuring Constant Power delivering up to 25% more power across all impedance loads. The frequency response of the T1000-1bdCP is optimized exclusively for use with subwoofers.

  • 24dB/octave crossover
  • 4 Gauge power/ground terminals
  • Audiophile grade speaker connections
  • MOSFET power supply
  • MOSFET output stage
  • RCA pass-thru
  • Infrasonic filter
Amplif15

KAC-7005PS Performance Series 5 Channel Power Amplifier

5Ch Design – Power your entire system with a single 5-channel amplifier.  This powerful one amplifier solution for front and rear speakers plus subwoofers, is an easy solution for any vehicle to enahnce your factory sound system.

Variable High-Pass Filter – Filters low frequencies out of the music and passes only signals above a certain frequency (called the cut-off frequency) to mid and high range speakers.

Variable Low-Pass Filter – Filters high frequencies out of the music and improves efficiency and sound quality by allowing only the low frequencies to pass to the subwoofer.

Variable Bass Boost – Adjust the fixed bass boost frequency (40Hz) to maximize natural bass performance.

 

Amplif16

KAC-8105D Performance Series Class D Mono Power Amplifier

The KAC-8105D Class D Mono Power Amplifier has a small foot print and a mighty powerful kick. Ready to pump out 1000 Watts Max Power, the KAC-8105D includes a built-in infrasonic filter that helps subwoofers perform their best by sharply cutting off inaudible frequencies below 15 or 25 Hz.

  • 1000 Watts of Power with 30% Smaller Chassis Size
  • CEA Rated: 300W (1.0% THD+N) (4Ohm/1Ch)
  • CEA Rated: 500W (1.0% THD+N) (2Ohm/1Ch)
  • High Quality Speaker Level Input and Blue Illumination
  • Variable low-pass filter (50-200 Hz at -24 dB per octave)
  • Bass Boost Control 0-18 dB at 40 Hz)
  • Infrasonic filter (15/25 Hz, 18 dB/octave)
  • Speaker-level inputs with signal sensing turn-on
  • Preamp-level inputs and outputs
  • 11-1/16″W x 2-3/8″H x 9-7/8″D

 

Authorized Dealer

Designed and maintained by Edge Unlimited Productions, LLC
Copyright © 2013 Bumper 2 Bumper